73 Tool Tolerances in MFL In-line Inspection and Why They’re Needed

Abstract

While the principle of magnetic flux leakage is relatively simple, it’s application in in-line inspection of carbon steel pipe is far more complex. MFL system design and analysis encompass complex interactions between the magnetic field and flux leakage produced by defects in the pipe wall, making signal identification & interpretation difficult. Thus, the need for tool tolerances.

This paper discusses the cause and effect of wide-ranging factors which influence the reported depths & dimensions of MFL In-line Inspection data. Including, 

  • Magnetic strength
  • Magnetic saturation
  • Residual magnetism
  • Pipe Wall Thickness
  • Velocity
  • Sampling Rates
  • Debris
  • Compressive and/or Tensile Residual Stress

Read/Download PaperGradeAvailable after the event