244

Debora Martogi1, Arash Mosaiebian2, Ali Ebrahimi1, Amir Ahmadipur1, USA.2

Debora Martogi1, Arash Mosaiebian2, Ali Ebrahimi1, Amir Ahmadipur1
1Geosyntec Consultants, Houston, USA. 2Enbridge, Calgary, Canada
The pipeline industry has been using vibrating wire (VW) strain gauges for monitoring pipelines traversing through landslides for the last 60 years. Strain gauges are typically installed in a rosette of three to four gauges at select locations along the pipe segment affected by the landslide. Data recorded from each gauge is typically collected in near real-time if the gauges are connected to a telemetry station that automatically transmits data from the site.

Strain gauges provide strain change measurements at pre-determined locations along the pipe segment since the installation of these strain gauges. In contrast, the Inertial Measurement Unit (IMU) bending strain plots provide continuous bending strain data along the segment of pipeline at the tool run date, and the strain change for subsequent IMU runs (e.g., every 1 to 10 years). Strain gauges allow pipeline operators to monitor strain accumulation on the pipe in between IMU runs and provide early notification if an intervention is needed to reduce the integrity risk on the pipeline due to a geohazard.

The strain gauge data plots are commonly presented as strain changes for each strain gauge’s location (e.g., 3 o’clock, 9 o’clock, 6 o’clock, and/or 12 o’clock) and the difference between the strain changes of two gauges (i.e., divergence). This paper presents an automated data analysis tool (i.e., Strain Gauge Module) that processes and analyzes the strain gauge data in near real-time and converts the strain changes measured at various locations around the pipe into a strain change distribution around the pipe. The Strain Gauge Module tool calculates the maximum tensile and compressive bending strain change, direction of pipe bending, and changes in the axial strain that are typically not calculated from an IMU tool run. These data are then automatically visualized and plotted, which can be utilized by Geohazards Integrity Engineers to make informed decisions.

Sample case studies will also be presented in this paper to highlight the implementation of the Strain Gauge Module tool on pipeline monitoring in landslide-prone areas during the monitoring and mitigation stages (i.e., strain relief, engineering mitigation).

Read/Download PaperGradeAvailable after the event