1RSI Pipeline Solutions, New Albany, USA
Ben Hanna, Michael Rosenfeld, Adam Steiner
RSI Pipeline Solutions, New Albany, USA
It has been historically presented that the size of a crack in a pipeline is the primary factor that controls the results of fitness-for-service assessments. The common practice for these assessments is to use the overall depth and length of the crack and approximate its shape as that of an idealized semi-ellipse, rectangle, or canoe. This can overestimate the area of the actual flaw and greatly overestimate the area that leads to failure, thus producing very conservative burst pressures and remaining lives. As inspection techniques improve, it is becoming more common for pipeline operators to have information on the detailed crack profile. A better assessment method is required to account for the increased fidelity of reported crack shapes. Some fracture mechanics models use an effective area approach (e.g., RSTRENG) where all contiguous combinations of the crack dimensions that make up the profile are evaluated. It is assumed that the area of the pipe wall removed by the crack dictates failure and an effective idealized shape can represent the failure. As such, either the length is established and an effective depth is calculated, or the depth is established and an effective length is calculated. The representative crack shape is the size that produces a limiting factor in the failure analysis. Usually, the minimum burst pressure is used to define the shape. A maximum stress intensity factor also has been employed recently. This paper investigates the use of an effective area approach on detailed crack profiles when calculating burst pressures and remaining lives. Specifically, the study addresses how the method breaks down when profiles become less ideal (i.e., more realistic). Both methods of calculating effective sizes were included, as well as both limiting factors. The investigation was performed considering four commonly used fracture mechanics methods (RSIM-3-04, MAT-8, Modified Ln-Sec, and Raju-Newman). The methods can produce vastly different effective shapes for the same crack depending on the detailed profile and analysis parameters. This paper identifies the boundary conditions for when each method is appropriate to use. Key words: crack management, fracture mechanics, burst pressure, effective area, crack profiles, remaining life
Available after the event



