269

Greg Morris, Tara McMahan, Matt Boring, Melissa Gould, Bill Bruce DNV, Dublin, USA

The pipeline industry has developed a robust set of procedures for implementing repairs to pipelines at locations identified through various pipeline integrity assessment methods. Requirements for pipeline repairs are found in the federal regulations (49 CFR Part 192 and 195) and in industry codes, including ASME B31.4 and B31.8. A commonly cited reference for pipeline repairs is the Pipeline Research Council International (PRCI) Pipeline Repair Manual (the repair manual), latest edition, [1]. The repair manual describes various pipeline repair methods, including grinding, composite sleeves, full-encirclement steel sleeves (Type A and Type B), and bolt-on mechanical clamps. The manual also includes less frequently used repair methods such as hot tapping, encapsulating with fittings, and epoxy-filled sleeves.

The guidance provided in the repair manual addresses many of the situations commonly encountered during pipeline repairs. The purpose of this paper is to supplement that guidance by describing situations, some commonly encountered and some less frequently encountered, as short case studies. The paper will address some of the risks associated with each situation and recommend techniques that can be used to mitigate those risks during installation of pipeline repairs.

Examples of situations that will be addressed include:

  • “Sweating” of an operating pipeline where a welded repair is planned. The sweating is caused by condensation of moisture from warm, humid air encountering a cooler operating pipeline. In the US, the phenomenon occurs more frequently in the summer months at locations downstream from pump or compressor stations where the pipeline has cooled to buried ground temperatures.
  • Laminations detected on the carrier pipe, or other manufacturing defects such as ‘burned steel’ in lapweld pipe[2] within the landing zone of a sleeve circumferential weld.
  • Considerations for recoating a pipeline after removal of rock or constraining object.
  • Sealing the annulus between the carrier pipe and the sleeve of Type A steel reinforcing sleeves to prevent corrosion of the carrier pipe and sleeve.
  • Evaluating the risks of fully welding or not fully welding a bolt-on mechanical clamp to the carrier pipe.
  • Considerations and recommendations for applying hardenable filler material, when recommended or required, to fill the void or annular space between the carrier pipe and repair sleeve.
  1. PRCI Pipeline Repair Manual – 2021 Edition
  2. History of Line Pipe Manufacturing in North America, 1996

Read/Download PaperGradeAvailable after the event