1NDT Global, Stutensee, Germany. 2Enbridge, Houston, USA. 3Pembina, Calgary, Canada
Landslides are a prevalent threat to pipelines and are actively managed through geohazard management programs. As the ground movement progresses and the loads on the pipeline increase, a pipeline operator must design and implement a mitigation plan. Mitigation may take many forms including stress relief by excavation, reinforcement of girth welds, or slope stabilization.
The strain mitigation design and timing will rely on estimating strain demand on the pipeline. ILI tools equipped with IMU can identify bending strain levels along the pipeline. If installed, strain gauges can monitor from the time of installation the longitudinal strain (axial and bending) at discrete locations. Additional information such as ground movement monitoring, slope inclinometer, or LiDAR helps to build a better picture of the soil interaction and the strain demand. However, historically it has been difficult to quantify the amount of axial strain present in the pipeline, since it often does not result in IMU bending strain changes and is often discrete and may not accumulate at the location of the strain gauge installation
In the case study presented, a complex slope at a river crossing presents two distinct areas of instability. A lateral slide at mid-slope oblique to the pipe and a longitudinal landslide at the bottom of the slope parallel to the pipe. The mid-slope, due to its oblique movement, was clearly identified in IMU bending strain data and monitored using repeat ILI inspection. The lower slope being parallel to the pipeline can potentially induce elevated compressive strains at the bottom of the slope. An FEA (Finite Element Analysis) model was developed and calibrated using the mid-slope bending strain to predict the axial strain components. A strain relief mitigation was initially planned to expose both sections of the slope based on the ILI and FEA results.
Prior to executing the strain relief, an additional technology was deployed to better estimate the axial strain component in the form of an ILI Strain tool capable of measuring both axial and bending strain. While the bending strain derived from the IMU and the Strain tool agreed in terms of location and magnitude, the axial strain profile predicted by the FEA seems to have overestimated the compressive axial strain at the bottom of the slope and underestimated the tensile axial strain mid-slope.
Considering the new data, the strain mitigation scope was revised to focus on the mid-slope section only in the absence of significant axial strain as measured by the ILI tool on the bottom slope. By deploying the additional ILI strain tool, the pipeline operator was able to target the mitigation effort and cost on the high-risk area in the mid-slope but also provided direct measurement in the bottom slope for ongoing monitoring efforts.
Available after the event



